Circuit Lab Simulator — iPhone & iPad
Email: thoexxr@hotmail.com
Please include your device model, iOS/iPadOS version, and a short description of the circuit or step that misbehaved. Screenshots help a lot. We answer within 2 business days.
邮箱 thoexxr@hotmail.com(请附设备型号、系统版本与问题描述,2 个工作日内回复)
Place a part
Tap 元件 at the bottom to open the parts drawer, pick a group (power, passive, semiconductor, IC, control, display, protection, instruments, digital, helpers) and tap the part — it lands on the canvas.
Wire it up
Drag from one pin dot to another to draw a wire. Every simulated circuit needs a ground symbol (接地); a voltage source must not form a loop of ideal sources.
Edit parameters
Tap a part, then open 参数. Resistor uses R, capacitor C, inductor L, DC source V — units are shown next to each field.
Run and read the result
Set 仿真时长 (length) and 时间步长 (time step), then tap ▶ 运行. The status bar reports node count, frame count and solve time. Open 波形 for the dual-channel oscilloscope; drag probes onto a node to watch that voltage.
Save and reopen
Tap the save button — the circuit is exported as a JSON file through the system share sheet. To reopen it, use the open button and pick the JSON file. Saving keeps every part, wire and parameter.
“元件两端接在同一网络上”
The solver found no voltage difference between pins. Usually a source value is 0, two pins overlap, or a wire short-circuits the part end to end. Check the source value and the wire you just drew.
“有引脚悬空”
A pin has no wire attached. Connect it, or ground unused pins of ICs and gates.
“方程组奇异”
Usually a missing ground, a floating sub-network, or an ideal voltage source loop (two ideal sources in parallel). Add a ground and break the loop with a small resistor.
The scope shows a flat line
The probe is not on a node, or the simulation was not run after the last edit. Tap ▶ 运行 again and check that CH1/CH2 are connected in the scope panel.
Canvas looks cropped on iPad
Double-tap empty canvas to fit the circuit to screen, or open 布局 to reset panel layout.
使用问题、仿真结果疑问或功能建议,请发邮件到 thoexxr@hotmail.com。 邮件中请写明:设备型号/系统版本、出问题的电路(可附 JSON 存档或用例名称)、期望结果与实际结果。 常见问题: